How to remove polylines gaps at vertices??

[PeterH]

I want to draw a centre-line linetype as a polyline and with a width.

When I do this the vertices are not filled like you see when drawing a
full line with width.

Is there a way to get a continuous full line at the vertices when using
a broken line of any sort (eg centre-line)?

Changing PLINEGEN does not seem to fix this.

Using ACAD 2005.

regards

PeterH

[Michael Bulatovich]

If you can uses separate segments for each side, you'll get a solid piece at
each end.
Other than that it's hit or miss by tweaking the ltscale.
--


MichaelB
www.michaelbulatovich.ca

<pshardie@oznetcom.com.au> wrote in message
news:1127371821.430983.187220@z14g2000cwz.googlegroups.com...I want to draw a centre-line linetype as a polyline and with a width. When I do this the vertices are not filled like you see when drawing a full line with width. Is there a way to get a continuous full line at the vertices when using a broken line of any sort (eg centre-line)? Changing PLINEGEN does not seem to fix this. Using ACAD 2005. regards PeterH

[Tim]

Hi

Can you not control the linetype display by double clicking the line to
bring up the properties box and then setting the linetype generation to
Enabled/Disabled in the misc. section at the bottom?

I think you need the disabled option

Try the following keywords in the help index, Pick the Modify or Join topic
and scroll down to the bottom and read the bit on Ltype Gen

polylines, linetypes, generating

Forgive me if I've got the wrong end of the stick here - this works for me

Best regards

Tim

If you can uses separate segments for each side, you'll get a solid piece at each end. Other than that it's hit or miss by tweaking the ltscale. <pshardie@oznetcom.com.au> wrote in message news:1127371821.430983.187220@z14g2000cwz.googlegroups.com... I want to draw a centre-line linetype as a polyline and with a width. When I do this the vertices are not filled like you see when drawing a full line with width. Is there a way to get a continuous full line at the vertices when using a broken line of any sort (eg centre-line)? Changing PLINEGEN does not seem to fix this. Using ACAD 2005. regards PeterH