IT Forums - ADT2004 Walls ?

Ed Sallade

07-02-2003, 05:24 AM

Is there a way in ADT2004 like there was in ADT2002 to convert existing
lines into walls?
Thanks,
Ed

Richard A

07-02-2003, 10:07 PM

Open the tool pallet that you want to use.
Scroll to display the tool that you want to use.
Right click a wall tool, and click Apply Tool Properties to > Linework.
Select the linework to convert and press ENTER.
When prompted to erase the original geometry, press ENTER to keep the
linework, or enter y (yes) to erase it.
Edit the properties of the new walls in the Properties palette, if needed.

"Ed Sallade" <ems2526@bjc.org> wrote in message
news:o2BMa.366$2y5.246639705@newssvr12.news.prodigy.com... Is there a way in ADT2004 like there was in ADT2002 to convert existing lines into walls? Thanks, Ed

The MyLounge.com forum is intended for informational use only and should not be relied upon and is not a substitute for any advice. The information contained on MyLounge.com are opinions and suggestions of members and is not a representation of the opinions of MyLounge.com. MyLounge.com does not warrant or vouch for the accuracy, completeness or usefulness of any postings or the qualifications of any person responding. Please consult a expert or seek the services of an attorney in your area for more accuracy on your specific situation. Please note that our forums also serve as mirrors to Usenet newsgroups. Many posts you see on our forums are made by newsgroup users who may not be members of MyLounge.com Term of Service