I realize the following question must be really elementary so a pointer
to NeXT documentation is appreciated. I've found documentation for
OpenStep. Here's the problem.
When I enter the cmd "bsd" or "bsd -s" I get a "bad version" message. I
think either of these cmds worked the last time I tried them and led to
launching of the GUI.
Any suggestions or pointers to docs greatly appreciated. This is a NeXT
Cube I recently purchased. I have a HD with OpenStep installed and am
trying to clone to a new HD I just purchased but have hit this problem.
The MyLounge.com forum is intended for informational use only and should not
be relied upon and is not a substitute for any advice. The information contained
on MyLounge.com are opinions and suggestions of members and is not a representation
of the opinions of MyLounge.com. MyLounge.com does not warrant or vouch for
the accuracy, completeness or usefulness of any postings or the qualifications
of any person responding. Please consult a expert or seek the services of an
attorney in your area for more accuracy on your specific situation. Please note
that our forums also serve as mirrors to Usenet newsgroups. Many posts you see
on our forums are made by newsgroup users who may not be members of MyLounge.com
Term of Service
Bad Version message
Linear Mode
